top of page

RC Frame vs Steel Frame: Choosing a Structure for a Small Development

Writer: Daniel Nikolla
Daniel Nikolla
6 days ago
2 min read

For a small residential or mixed-use scheme, the structural frame sets the programme, the foundation design and much of the cost. The two most common choices are an in-situ reinforced concrete (RC) frame and a steel frame. Neither is better in every case, and the right answer depends on the site, the building and what the end use demands.

How an RC frame works

An RC frame is cast on site from concrete reinforced with steel bars, usually as columns and flat or beam-and-slab floors. It is robust, offers good fire resistance and sound insulation between floors, and can be shaped to awkward footprints. Its drawbacks are the time needed for formwork, reinforcement and curing, and the dependency on concrete deliveries and weather. We cover the method in more detail in our guide to RC frame construction for small developments.

How a steel frame works

A steel frame is fabricated off site and erected quickly, which can shorten the structural programme and keep the site cleaner. Steel is lighter than concrete, so foundations may be smaller. The trade-offs are fire protection, which has to be added with boards or intumescent coatings, extra attention to acoustic separation between floors, and long lead times when the steel market is busy.

Questions that decide the choice

  • Ground and foundations. A lighter steel frame can reduce foundation loads on poor ground, while an RC frame can suit a basement or podium where concrete is needed anyway. See our note on groundworks and foundations.

  • Programme. Steel erects fast but depends on early design freeze and fabrication slots. RC allows more flexibility on site but needs time for each pour to cure.

  • Site access and logistics. Tight London sites can limit crane position, delivery sizes and concrete pumping. The access constraints often decide the method.

  • Building height and use. Taller and mixed-use buildings bring fire, acoustic and Building Safety Act considerations that should be tested early. Our guide to Gateway 2 explains when these apply.

  • Finishes and services. Exposed concrete soffits, flat slabs and service routes all affect floor-to-floor heights and fit-out.

Getting the decision right

The most reliable way to choose is to test both options against the actual site and programme with your structural engineer and contractor before design is frozen. Early contractor input helps here, which is the idea behind pre-construction services and value engineering. Cost differences move with the market, so ask for a current comparison rather than relying on rules of thumb.

Berati Construction works with developers, landlords and homeowners across London and the South East. If you are weighing up a project like this, get in touch and we will talk through scope, programme and budget before you commit.

Comments


bottom of page
Web design by Merx Marketing